Volume 6, Issue 1, June 2019, Page: 24-26
Features of the New Defect Indicator on the Gorbunov Effect
Sutorikhin Vladimir, Faculty of Radio Engineering, Tomsk University of Control Systems and Electronics, Tomsk, Russia
Received: Jul. 21, 2019;       Accepted: Aug. 21, 2019;       Published: Sep. 4, 2019
DOI: 10.11648/j.ajae.20190601.14      View  505      Downloads  103
It's been 20 years since the opening of the new phenomenon of ultrasonic treatment on defects in the metal, which ingibiruetsa Doppler radar. The former results from the application of radar to monitor defects limited to surface discontinuities under the paint layer, other dielectric coatings. A new direction of remote detection of metal defects (cracks, metal stratification at a depth of several tens of centimeters) by Doppler radar of 30-40GHz frequency is now possible. Developed, tested sensor contactless indexing of acts of acoustic emission. A device for indicating defects that could previously be detected only by contact sensors based on piezoelectrics was tested. The paper deals with the causes of previous failures, low sensitivity of radars with their direct p. the possibilities of increasing the sensitivity due to the joint use of ultrasound and microwave radiation are Shown. The obtained results require a revision of the capabilities of the known ultrasonic flaw detectors of active and passive principle of action.
Active, Passive Ultrasonic Methods, Gorbunov Effect, Doppler Radar
To cite this article
Sutorikhin Vladimir, Features of the New Defect Indicator on the Gorbunov Effect, American Journal of Aerospace Engineering. Vol. 6, No. 1, 2019, pp. 24-26. doi: 10.11648/j.ajae.20190601.14
Copyright © 2019 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Contactless acoustic emission Converter, D. Merson, Togliatti state University, Togliatti, journal of strength physics and intelligent diagnostic systems, 2014.
Gorbunov V. I., Grankin A. P. and others A. S. № 1578636. Method for recording acoustic emission signals. Priority of the invention 4364845, registered 28 October 1987.
Darznek S. A., Jacobi J., Laser interferometric nanodisplacement meter, /RAS, proceedings of General physics Institute. A. M. Prokhorova, volume 62, 2006.
Podymova N., Karabutov A., Belyaev I., Broadband laser-ultrasonic spectroscopy for quantitative evaluation of porosity effect on acoustic attenuation and phase velocity in CFRP composites/ECNDT, Prague, October 2014, p 2001.
Remote acoustic emission Converter. V. I. Gorbunov, V. A. Sutorikhin,/Journal Of Applied Physics", Tomsk, 1995. - DEP. in VINITI 26. 06. 95 №1869-B 95. 4 PP.
G. C. Smith and S. S. Lee, Method for detecting tool wear on a CNC lathe using a Doppler radar detector, Int. J. Adv. Manufact. Technol., vol. no. 3-4 pp. 270-280, 2004.
The POSSIBILITY of INSPECTION of METAL PARTS of the microwave FIELD V. I. Gorbunov, V. A. Sutorikhin/Technical acoustics. 2010. Vol. 10. P. 16.
Metod for detection acoustic emission using a microwave Dopler radar detector. /Inventor: Gregory C. Smith. /Patent No US 7. 397. 421. B2, Jul. 8, 2008.
Kapranov B., Sutorikhin V., The theoretical limit on the measurement of the signals of Acoustic Emission the Doppler., NORWEGIAN JOURNAL OF DEVELOPMENT OF THE INTERNATIONAL SCIENCE 2017. Р. 23-26.
Remote Acoustic Emission Monitoring of Metal Ware and Welded Joints To cite this article: Boris I Kapranov and Vladimir A Sutorikhin/2017 IOP Conf. Ser.: Mater. Sci. Eng. 253 012005 IOP Conference Series: Materials Science and Engineering.
Browse journals by subject